Docking method of vibrating disk PU conveyor belt

1. This method is suitable for precision vibration plate round belts with a general diameter of more than 10mm, and All kinds of V-belts, pattern belts and other belts can be applied.


2. Adapter composition: aluminum fixture, constant temperature heater, scissors.

3. How to use:

1. Fixed. Fix the belt to be connected in the groove (usually V, O-shaped groove) under the aluminum clamp (the splint mainly refers to the washer and the nut).

      Specific method: remove the washer fixed by the nut and nut on both sides (depending on the diameter of the belt, if the belt can be directly inserted into the groove, it is not necessary to remove the nut and washer), and put the belt into the recess Slot, re-fix the washer and nut on the top of the groove, the splints on both sides are parallel, and the distance is about 2cm (the thermostat heater can be placed in the middle);

2. Heating. The thermostat heater is energized to a constant temperature (the best temperature for belt connection is 160-180 degrees), and the fixed belt is heated (provided that no bubbles appear on the heated belt, otherwise the connection effect will be affected), and then the Tighten the nut of the manual clamp until the belt is tightly connected;


3. Reprocessing. Vibration plateThe belt is connected to each other. After it has cooled down completely, take it out and scrape the belt. , Xiuping.